Almost every expensive repair started as a cheap one.

It usually starts with a water bill. Forty dollars higher than last month, then forty higher again, and nothing in the house looks wet. By the time a warm spot shows up on the tile, water has been moving under the slab for weeks. That case is exactly what electronic leak detection exists for, and the pattern behind it, a cheap problem left alone until it isn’t, sits behind most of the big invoices in residential plumbing.

Phoenix makes the pattern worse. Water at 10 to 20 grains of hardness scales up water heaters years early. Polybutylene supply pipe, installed in many homes built from roughly 1978 to 1995, fails from the inside out, which is what the repipe decision comes down to. And nearly every house here sits on a slab, so a supply leak has nowhere to go but sideways. The $14,000 drip follows where it goes.

The logic also runs in reverse. Some things can wait, and we will say so. A water heater with three good years left doesn’t need replacing this week, and our technicians aren’t paid on commission to argue otherwise. When a job is big enough to sting, financing spreads it out.

Below is everything we do for homes, grouped by the part of the system it belongs to. Every job is quoted flat before we start, photographed as we work, and done by licensed technicians under Arizona ROC #340524.